- 38 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setRemoving the Transport Protection from the Guide Rails12.3Langer EMV-Technik GmbH applies a thin layer of grease to all sliding rails so as to ensureappropriate corrosion protection during transport and storage. Remove this grease before puttingthe system into service.Figure 36: Cleaning the greased sliding rails with a paper towelUse dry towels made of cloth or fabric to remove the grease. Dispose of the towels under dueconsideration of the local, official regulations.Prevent the grease from coming into contact with your clothes, skin, hair and eyes.Wash the grease off with water and soap if it comes into contact with your skin.Information on the Pre-Installed Components' Torque12.4All components for which a special tightening torque is defined have already been installed andtightened.The screws of all attachments that have to be installed later should only be fastened hand-tight. Notorque wrench is needed for this purpose.
