- 70 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setConnecting a Near-Field Probe Directly to the FLS 106 PCB Scanner18.2.1If operated without a pre-amplifier, the RF measuring cable has to be connected to the near-fieldprobe's measurement output and directly to "RF in" input on the scanner's Z-axis tower(Figure 105).Figure 105: Connecting the respective RF measuring cable to the near-field probe and the "RF in" connector on the Z-axis towerConnecting a near-field probe with a pre-amplifier18.2.2Note: The selection of the correct pre-amplifier depends on the measurement task and the near-field probe used. Please contact us should you have any queries (chapter 24).Connect the pre-amplifier's SMA output to the "RF in" input on the scanner's Z-axis tower(Figure 106).Figure 106: Pre-amplifier on the scanner's "RF in" inputConnect the near-field probe's RF measuring cable to the pre-amplifier's SMA input (Figure 107).Connect the pre-amplifier's power supply cable to the "12 V DC" connector on the Z-axis tower(Figure 108).
