- 51 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB set8. When installation is complete, you can decide whether to start the software immediately ornot by ticking the appropriate checkbox.9. Click "Finish".Putting the FLS 106 Scanner into Service with the15.3ChipScan-Scanner SoftwareEnsure that the system has been set up as described in chapter 13 (item a – m) and the driverdescribed in section 15.1 has been installed.The ChipScan-Scanner software user manual with additional information on the individual stepscan be accessed if the software is open via the "Manual" entry in the "Help" menu.The scanner and the PC must be switched on and connected via a USB 2.0 cable.The following steps have to be carried out to check whether the FLS 106 scanner functionsproperly:1. Start the ChipScan-Scanner software.2. Connect the ChipScan-Scanner software to the FLS 106 scanner:- Click the "Device Manager…" entry in the "Devices" menu in the ChipScan-Scannersoftware.- Click the "Detect Devices" button.- Searching for the connected devices takes some time. The following entries should thenappear in the "Identified devices used for measurement" section:o In the "Video Device" selection box -> Name of the connected camerao In "Scanner" selection box -> Name of the connected scannero In the "Spectrum Analyzer" selection box -> Name of the connected spectrumanalyzer- Optional steps to speed up the device identification:In the open "Device Manager" window:o Select the COM interface to which the scanner is connected in the "RS232"selection box in the "Scanner" section.o Select the "Langer FLS 106" entry in the selection box below "RS232".o Then click the "Detect Devices" button.- After a successful search, close the "Device Manager" by clicking the cross in the upperright corner.- Please refer to chapter 4 in the ChipScan-Scanner software user manual for furtherinformation.
