- 55 / 79 -LANGEREMV-TechnikDE-01728 Bannewitzmail@langer-emv.dewww.langer-emv.de FLS 106 IC set / FLS 106 PCB setFigure 63: Fastening example with claw 02The claws have to be fastened so that the circuit board cannot be moved in any direction.The remaining claws can also be used for this purpose.Installing the UH DUT16.2.1Note: Scratches and/or other traces may be left on the T-slot table if the clamping pieces arefastened too tight. Take due care.Place the UH DUT universal holder on the T-slot table precisely in the middle between two T-nuts(Figure 64).Figure 64: Positioning the UH DUTInsert a T-nut into each of the T-slots directly alongside the UH DUT and push them up to themiddle of the UH DUT.Place the clamping pieces above the T-nuts and secure loosely with the hexagon socketscrew M6.
