Page 62 of 906 Overview553-3001-211 Standard 3.00 August 20053 Install the cable that connects the backplane connector on the IPEmodule to the module I/O panel.4 Connect a 25-pair cable from the module I/O panel connector to the MainDistribution Frame (MDF).5 Connect the trunk card output to the selected terminal equipment at theMDF.6 Configure the individual trunk interface unit using the TrunkAdministration program (LD 14) and the Trunk Route Administrationprogram (LD 16).Once these steps have been completed, the trunk card is ready for use.Figure 10IPE trunk cards installed in an NT8D37 IPE moduleIntelligentPeripheral EquipmentSuperloopShelfIPEPE ModulePE Pwr Sup Rng GenIntelligent line cardsIntelligent trunk cardsBRSCIntelligent line cardsIntelligent trunk cardsBRSCNT8D01 Controller Card553-63210 2 3 4 5 6 7 Cont 9 11 12 13 151 8 1410
