Page 846 of 906 NTVQ55AA ITG Pentium card553-3001-211 Standard 3.00 August 2005Functional descriptionFigure 181 on page 847 shows the ITG-P card faceplate components. Theinformation in this section describes the components.Faceplate componentsNWKThe faceplate connector labeled NWK is a 9-pin, sub-miniature D-typeconnector. The connector is not used for the ITG-P application.ITG-P LED (Card Status)The red status faceplate LED indicates the enabled/disabled status of the24-card ports. The LED is on (red) during the power-up or reset sequence.The LED remains lit until the card is enabled. If the LED remains on, thisindicates the self-test failed, the card is disabled, or the card rebooted.Reset switchPress the Reset switch to reset the card without having to cycle power to thecard. This switch is normally used after a software upgrade to the card, or toclear a fault condition.WARNINGThe NWK connector looks like a 9-pin serial connector.Do not connect a serial cable or any other cable to it. If acable is installed to the NWK connector, the TLANinterface card is disabled.
