Page 90 of 906 Acceptance tests553-3001-211 Standard 3.00 August 2005Conference cardsProcedure 2Testing conference cardsUse this procedure to test a conference card or to test the conference functionof an NT8D17 Conference/TDS card.1 Log into the system:LOGI (password)2 Request the status of a loop on the conference card:LD 38STAT loopConference status is formatted as follows:CNFC n DSBL n BUSY“n” represents the number of conference groups disabled and busyCHAN n DSBL n BUSY“n” represents the number of channels disabled and busyUNEQcard is not equipped in the systemDSBLcard is disabled in software3 If the conference card loop is disabled, enable it.For an NT8D17 Conference/TDS card, enter:ENLX loop(the conference loop is the odd loop of the conference/TDS loop pair)Note: The conference/TDS card is not enabled automatically when it isinserted. You must enable the card with the command ENLX. (Thiscommand is used in LD 34 and LD 46 to address even loops and in LD 38to address odd loops.) Enabling the loops with the command ENLL doesnot enable the hardware for the card.For other than an NT8D17 Conference/TDS card, enter:ENLL loop(the conference loop must be an even loop for cards other than theNT8D17)If the system response is other than OK, see the Software Input/Output:Administration (553-3001-311) to analyze the messages.
