OHAUS Ranger 7000 Instruction Manual

Also see for ranger 7000: Instruction manual Instruction manual Quick start guide Instruction manual Instruction manual

Contents

OHAUS Ranger 7000 Instruction Manual Manual pdf 21 page image

RANGER®7000 SCALES EN-194.3 CheckCheck is used to compare the weight or pieces of a sample against target limits.Press the button until Check is displayed in the upper left portion of the home screen.Two different modes can be selected: Weight and Pieces.Three different methods to enter the check limits: Over and Under, Nominal Weight Tolerance, or NominalPercent Tolerance.Setup check limits according to section 4.3.1 or 4.3.2. Place object on the pan to check if the weight is within thelimits.4.3.1 Check Weighing (default)Make sure that the check mode is set to check weighing in the configuration menu .Place objects on the pan. The Under/Accept/Over status is shown in the progress bar area while the actual weightof the item is shown on the main Display Line.The CHECK Home screenMain Display LineReference FieldsFunctions Application IconNote: Refer section 9.5, or press the button for button icon explanation.Defining Over/Under Limits and TolerancePress the button corresponding to the icon to enterLimit Setup.Select Over or Under Limit and press the buttoncorresponding to the icon to edit the value.Enter the desired value for the limit using the alphanumericalkeypad. Then press the button corresponding to theicon to set the value and go back to previous screen.Alternatively, the limits can be set by Target WeightTolerance.To set the tolerance, press the button corresponding to theicon to enter the Tolerance setup.www. .com information@itm.com1.800.561.8187