OHAUS Ranger 7000 Instruction Manual

Also see for ranger 7000: Instruction manual Instruction manual Quick start guide Instruction manual Instruction manual

Contents

OHAUS Ranger 7000 Instruction Manual Manual pdf 8 page image

EN-6 RANGER®7000 SCALES2.2 Installing ComponentsRefer to the illustrations and instructions below to identify and assemble your Ranger 7000 scale with itscomponents. All components must be assembled before using the scale.2.2.1 Terminal SetupWhen the Ranger 7000 is delivered, the Terminal is already attached (docked) to the Base. No additional setup isnecessary. Refer to the illustrations and instructions below to identify and assemble your Ranger 7000 Scale.Note: The Terminal is identical for all Ranger 7000 Scale models.2.2.2 Installing the Wind Ring, Weighing Platform1. Place the Wind Ring in position(R71MHD3, R71MHD6).2. Place the platform onto thespider.2.3 Selecting the LocationAvoid excessive vibrations, heat sources, air current, or rapid temperature changes. Allow sufficient space.Note: Interface cables connect to the terminal. The terminal can be detached and mounted on a wall orpositioned on a table separate from the scale.2.4 Connecting Power and Turning ON the ScaleThe Ranger 7000 comes with an AC power cord. Connect the power cord to a suitable grounded electrical outletand press the ON button on the side of the base (see figure below).Power ON button on the side of the baseAttention: Allow equipment to warm up for 60 minutes for optimal weighing performance.Power ON Buttonwww. .com information@itm.com1.800.561.8187