OHAUS Ranger 7000 Instruction Manual

Also see for ranger 7000: Instruction manual Instruction manual Quick start guide Instruction manual Instruction manual

Contents

OHAUS Ranger 7000 Instruction Manual Manual pdf 55 page image

RANGER®7000 SCALES EN-535.9.7 Reference BalanceOff = do not connect to reference balanceOn = connect to reference balanceNote: Use reference balance to perform sampling with high resolution balance in Counting Mode.Please make sure the balance is already switched on before connecting to Ranger 7000.Alternate Print CommandSet the alternate command character for Print.Settings of A(a) to Z(z) are available, except T&Z. The default setting is P.Alternate Tare CommandSet the alternate command character for Tare.Settings of A(a) to Z(z) are available, except P&Z. The default setting is T.Alternate Zero CommandSet the alternate command character for Zero.Settings of A(a) to Z(z) are available, except P&T. The default setting is Z.Print Setup Menu: (RS232 shown)5.9.8 ResetResets the settings to factory default settings. Reset the settings to factory defaultsettings.5.9.9 Stable Weight OnlySet the printing criteria.OFF = values are printed immediately, regardless of stability.ON = values are printed only when the stability criteria are met.5.9.10 SICSOff = disable MT-SICS commandOn = enable MT-SICS command5.9.11 Print OptionsSet the printing criteria.PC = Print data to a PCPrinter = Print data to a printer5.9.12 Auto PrintSet the automatic printing functionality.Auto Print ModeOFF = disabledON STABLE = printing occurs each time the stability criteria are met.INTERVAL = printing occurs at the defined time interval.ACCEPT = printing occurs each time the display is within the Checkweigh acceptrange and stability criteria are met.CONTINUOUS = printing occurs continuously.When ON STABLE is selected, set the time interval using the numeric keypad.LOAD = prints when the displayed load is stableLOAD ZERO = prints when the displayed load or zero reading is stable.When INTERVAL is selected, set the time interval using the numeric keypad.Settings of 1 to 50000 seconds are available.Note: Pressing the print button when INTERVAL has been selected will print the displayed resultimmediately.ContinuousOHAUS = Compatibility with OHAUS products that require real-time weight dataMT Standard = Compatibility with METTLER TOLEDO products that require real-timeweight datawww. .com information@itm.com1.800.561.8187