OHAUS Ranger 7000 Instruction Manual

Also see for ranger 7000: Instruction manual Instruction manual Quick start guide Instruction manual Instruction manual

Contents

OHAUS Ranger 7000 Instruction Manual Manual pdf 66 page image

EN-64 RANGER®7000 SCALES6. SERIAL COMMUNICATION6.1 Interface CommandsThe scale supports both MT-SICS and OHAUS commands. Commands listed in the following tables will beacknowledged by the scale. To use the MT-SICS commands, send the command PSI. To return to the OHAUScommands, send the command POH.SICS commands can also be active in the menu setup, please refer to Section 5.9.10 for detail.OHAUS CommandsCommand FunctionIP Immediate Print of displayed weight (stable or unstable).P Print displayed weight (stable or unstable).CP ContinuousSP Print on Stability.xS 0S: Turn off “Stable Only” menu item and allow unstable print. 1S: Turn on “Stable Only” menu itemand only print stable print.xP Interval Print x = Print Interval (1-50000 sec), 0P turns auto print OFFZ Same as pressing Zero Key.T Same as pressing Tare Key.xT Download Tare value in grams (positive values only).Sending 0T clears tare (if allowed).PU Print current unit: g, kg, lb, oz, lb:ozxU Set scale to unit x: 1=kg, 2=lb, 3=g, 4=oz, 5=lb:ozxM Set scale to mode x. 1=Weighing, 2=Counting, 3=Check, 4=Formulation, 5=Percent, 6=Filling,7=Dynamic, 8=Density, 9=Differential. M will scroll to next enabled mode.PSN Print Serial Number.CU xxx Set Under Limit (only in Check mode) where ‘xxx’ is the value under current unitCO xxx Set Over Limit (only in Check mode) where ‘xxx’ is the value under current unitx# Set Counting APW (x) in grams. (only in Counting or Checkcounting mode, must have APW stored)P# Print Counting or Checkcounting mode APW.x% Set Percent mode reference weight (x) in grams. (must have reference weight stored)P% Print Percent mode reference weight.PV Version: print name, software revision and LFT ON (if LFT is set ON).H x "text" Enter String content, x = String number (1-10), "text" = string text up to 40 alphanumeric characters.\EscR Global reset to reset all menu settings to the original factory defaults.SNS x Switch the platform: x = 1, 2MT-SICS CommandsCommand FunctionLEVEL 0 @ Reset the scaleI0 Inquiry of all available SICS commandsI1 Inquiry of SICS level and SICS versionsI2 Inquiry of scale dataI3 Inquiry of scale software versionI4 Inquiry of serial numberS Send stable weight valueSI Send weight value immediatelySIR Send weight value repeatedlyZ Zero the scaleZI Zero immediatelyLEVEL 1 D Write text into displayDW Weight displaySR Send and repeat stable weight valueT TareTA Tare valueTAC Clear tareTI Tare immediatelywww. .com information@itm.com1.800.561.8187