OHAUS Ranger 7000 Instruction Manual

Also see for ranger 7000: Instruction manual Instruction manual Quick start guide Instruction manual Instruction manual

Contents

OHAUS Ranger 7000 Instruction Manual Manual pdf 69 page image

RANGER®7000 SCALES EN-676.3.3 Virtual Port Software Installation1. Insert the supplied CD into the computer’sCD drive.Different versions of Windows have slightlydifferent steps to load the driver that is onthe CD. In all versions the New HardwareWizard guides you through the requiredsteps to select the driver that is located onthe CD.2. After clicking Finish, the virtual port shouldbe ready for use.Windows typically adds the virtual port insequence after the highest number COMport. For example, on PC’s equipped withup to 4 COM ports, the virtual port will beCOM5.When using the USB interface withprograms that limit the number of COMport designations (e.g. OhausMassTracker allows only COM1, 2, 3, & 4),it may be necessary to assign one of theseport numbers to the new virtual port.Example of Windows XP Hardware WizardThis can be done in the Port Settings of the Device Manager utility, found in the Windows Control Panel.6.4 USB HostThe USB Host can be used to connect a barcode scanner and USB flash drive to the Ranger 7000.6.5 Printout FormatPrintout string for g, kg, lb, oz units:Check Weighing application:Field Weight(Rightaligned)Space Unit(Rightaligned)Space Stability(?)Space T/N/G/PT(Rightaligned)Space ApplicationStatus(Right aligned)Term.Length 11 1 5 1 1 1 2 1 6 2Non-Check Weighing application:Field Weight(Rightaligned)Space Unit(Rightaligned)Space Stability(?)Space T/N/G/PT(Rightaligned)Term.Length 11 1 5 1 1 1 2 2Each field is followed by a single delimiting space (ASCII: 32).Definitions:Weight - Up to 11 characters, right justified, - at immediate left of most significant character (if negative).Unit - Up to 5 characters, right justified. If the Unit in the Print Content menu was set to OFF, the unit will beremoved in the weight string and replaced by spaces.Stability - “?” character is printed if not stable. If weight is a space is printed.T/N/G/PT - “T” is printed for a tare weight, “N” printed if weight is net weight, ‘G’ or nothing printed if weight is agross weight, 'PT' is printed if the tare weight is Pre-set Tare.Application Status (for Check) – Fixed to 6 characters. Display status like " Under", "Accept" and "Over" for checkweighing.Terminating Character(s) - terminating character(s) printed depending on FEED menu setting.www. .com information@itm.com1.800.561.8187