5-415STORING, USING AND DELETINGJOB PROGRAMSThe steps of up to 10 copy jobs can be stored as job programs. Job programs can be called up with ease, and areretained even when the power is turned off. By storing frequently used copy settings in a job program, you caneliminate the bother of selecting the settings each time you use them for a copy job.If any settings related to the steps of a job program are changed in the key operator programs after the job programis stored, the steps related to the changed settings will not be included when the job program is called up.To exit the job programs mode, press the [CA] (clear all) key on the operation panel or touch the [EXIT] key on thetouch panel.Storing a job program1 Press the [#/P] key.2 Touch the [STORE/DELETE] key.3 Touch the number key ([1] to [10]) in whichyou wish to stored the job program.Number keys in whichjob programs arealready stored arehighlighted.4 Select the copy settings that you wish tostore in the job program.The number of copiescannot be stored.5 Touch the [OK] key.The selected settingswill be stored in thenumber key selected instep 3. If a number key is selected in step 3 that hasalready been programmed.A setting confirmation screen will appear. To replacethe existing program with the new program, touchthe [STORE] key and continue from step 4. If you donot wish to replace the existing program, touch the[CANCEL] key to return to the screen of step 3 andselect a different number key.M NUMBER.RECALL STORE/DELETEPROGRAMSESS PROGRAM NUMBER.RECALL STORE/SPECIAL MODESTO STORE, MAKE SELECTIONS AND PRESS[OK], TO DELETE, PRESS [CANCEL].2-SIDED COPYOUTPUT8 x118 x118 x1411x71/21/21/2NOTEIf overwriting of programmed copy settings has beenprohibited in the key operator programs, you will notbe able to store a job program. (See page 15 of thekey operator's guide.)AUTOAUTOORIGINALOKNCEL
