STORING, USING AND DELETING JOB PROGRAMS5-42Calling up a job program1 Press the [#/P] key.2 Touch the number key of the desired jobprogram.The screenautomatically closes andthe job program is calledup. A number key thatdoes not have a jobprogram cannot beselected.3 Set the number of copies if needed andthen press the [START] key.Copying will begin usingthe settings of the jobprogram.Deleting a stored job program1 Press the [#/P] key.2 Touch the [STORE/DELETE] key.3 Select a storage register number of theprogram to be deleted.If a number key for whichno job program hasbeen stored is selected,the screen will change tothe screen of step 4 onthe previous page (forstoring a job program).4 Touch the [DELETE] key.The selected program isdeleted and you returnto the screen of step 3.To return to the screenof step 3 without deletingthe job program, touchthe [CANCEL] key. Inboth cases, touch the[EXIT] key on the screen displayed in the screen ofstep 3 to exit the job program mode.JOB PROGRAMSPRESS PROGRAM NUMBER.RECALLM NUMBER.RECALL STORE/DELETEEXITSTORE/DELETENOTEIf overwriting of programmed copy settings has beenprohibited in the key operator programs, you will notbe able to clear a job program. (See page 15 of thekey operator's guide.)REC LL STORE/DELETEA JOB PROGRAM HAS BEEN ALREADY STOREDIN THIS LOCATION.CANCEL DELETE STORE
