Oce im4511 Operation Manual

Also see for im3511: Programming Date & Time Facsimile operation manual Operation manual Operating manual Operator's guide

Contents

Oce im4511 Operation Manual Manual pdf 85 page image

4-54CHECKING THE SIZE OF A PLACEDORIGINALIf the placed original is a standard size, the size will be automaticallydetected (automatic original detection function) and displayed in the touchpanel. Make sure that the correct size has been detected.(A) :The original size is displayed.(B) :[AUTO] appears when the automatic original detection function isoperating.If you have loaded a non-standard size original or wish to change thescanning size, you can follow the steps below to manually set the originalscanning size. (For the standard sizes, see "Original size detectionfunction" on page 4-3.)Manually setting the scanning sizeIf you load an original that is not a standard size (such as an AB size), or if the size is not detected correctly, you musttouch the [ORIGINAL] key and set the original size manually. Perform the following steps after placing the documentin the automatic document feeder or on the document glass.1 Touch the [ORIGINAL] key.2 Touch the desired original size key.[AUTO] is no longerhighlighted. [MANUAL]and the original size keyyou touched arehighlighted.If you wish to select an AB size, touch the[AB/INCH] key and then touch the desiredoriginal size key.[AB] is highlighted andAB size keys aredisplayed. To return tothe inch palette, touchthe [AB/INCH] key onceagain.If a non-standard size original is placed inthe document feeder or on the documentglass, touch the [SIZE INPUT] tab and thenenter the X (width) and Y (length)dimensions of the original.X is initially selected.Enter the X dimension(width) and then touchthe Y( ) key and enterthe Y dimension (length).X can be from 2-1/2 to 17inch, and Y can be from2-1/2 to 11-5/8 inch.If you frequently use originals that are the samenon-standard size, you can store the size asexplained in "STORING, DELETING, AND USINGORIGINAL SIZES" on the following page. This willsave you the trouble of manually entering the sizeeach time you use that original size.3 Touch the [OK] key.You will return to the initial screen.4 The selected original size appears in thetop half of the [ORIGINAL] key.AUTOAUTOORIGINALEXPOSURE08 x111/2(B)(A)NOTEIf a non-standard size original is loaded (including special sizes), the closest standard size may be displayed,or the original size may not appear at all.If "CANCEL DETECTION AT DOCUMENT GLASS" is enabled in the key operator programs (see page 11 ofthe key operator’s guide), automatic original detection at the document glass will not operate. In this case,follow the steps below to manually set the original scanning size.AUTOAUTOORIGINALEXPOSURE0STANDARD SIZE SIZE INPUTINCHABOK5 X85 X8 R8 X11R8 X118 X138 X1411X171/2 1/21/2 1/21/21/21/21/2A5B5A5RA4B4A3STANDARD SIZE SIZE INPUTINCHABOKA4RB5R(2 1/2 11 5/8)inch(2 1/2 17)inchXYXYSTANDARD SIZE SIZE INPUT1711 5/8OKAUTOORIGINALEXPOSURE0A4