SETTING N/W-Fax DRIVER- 151 -21345679) MessageCheck this to have a message appear on the cover sheet.You can enter the message in up to 500 characters.10) [Restore Defaults]Click this to restore the default setting values.Setting up the SNMPIf the recipient’s MFP is not found over the Internet and the faxjob is not sent normally, the SNMP settings may be the cause.Check that the SNMP settings are correct in the [SNMPSettings] dialog box, and if not, change them.Note• Ask the administrator for details on the SNMP Networksettings configured for your MFP.1) VersionBe sure to have the correct SNMP version set for your MFPand select from the following options:- V1/V2 — Select this option to enable SNMP V1 and V2.- V3 — Select this option to enable SNMP V3.- V1/V2/V3 (for [Discovery Settings] dialog box only)— Select this option to enable SNMP V1, V2, and V3.2) SNMP V1/V2Community Name — If a community name other than“private” (default) is set for the SNMP community name foryour machine, enter its community name.Note• To send fax jobs normally under an SNMP V1/V2environment, the SNMP community names must be thesame in the 3 settings shown below.- Your machine- [SNMP Settings] dialog box of the [SenderInformation] tab- TCP/IP port of the [Ports] tab in the N/W-Fax driver• To change the community name, the administratorprivilege is necessary. You must log in with the“Administrator” privilege and open the printer driverproperties.• Up to 31 characters including the following symbols canbe entered for the Community Name.! " # $ % & ' ( ) * + , - / : ; < = > ? @ [ \ ] ^ _ ` { | } ~1234
