SETTING ITEMS (ADMIN)- 285 -2134567Memo• When you press [USER NAME], [NEW PASSWORD]or [RETYPE NEW PASSWORD], the on-screenkeyboard is displayed.For details of the on-screen keyboard, see thefollowing page: P.300 "On-screen keyboard"• The input password appears as asterisks (*) in the[NEW PASSWORD] and [RETYPE NEW PASSWORD]boxes.802.1X SETTINGSYou can make settings for IEEE 802.1X authentication that willapply to wired networks.This equipment supports the following authentication methods:• EAP-MSCHAPv2• EAP-MD5• EAP-TLS• PEAP *1The following protocols are available for innerauthentication:- EAP-MSCHAPv2• EAP-TTLSThe following protocols are available for innerauthentication:- PAP- CHAP- EAP-MSCHAPv2- EAP-MD5*1 PEAP cannot be used for Windows Server 2008.To enable IEEE 802.1X authentication, you must installcertificates in this equipment as required, using TopAccess.The certificates that must be installed are as follows.*1 The CA certificate must be installed in this equipment before thesettings for IEEE 802.1X authentication are performed.*2 The user certificate must be installed in this equipment before thesettings for IEEE 802.1X authentication are performed.Memo• For instructions on how to install certificates, refer to theTopAccess Guide “Chapter 8: [Administration] TabPage”.• For instructions on how to display the WIRED 802.1XSETTINGS screen, see the following page: P.232 "Accessing the Admin Menu"Setting IEEE 802.1X authentication1 On the WIRED 802.1X SETTINGS screen,specify the following items as required andpress [NEXT].Authentication MethodInnerAuthentication MethodCACertificateUserCertificateEAP-MSCHAPv2- - -EAP-MD5 - - -EAP-TLS - Necessary*1 Necessary*2PEAP EAP-MSCHAPv2Necessary *1 -EAP-TTLS PAP Necessary *1 -CHAP Necessary *1 -EAP-MD5 Necessary *1 -EAP-MSCHAPv2Necessary *1 -Item name Description802.1X • ENABLE — Press this buttonto use IEEE 802.1Xauthentication.• DISABLE — Press this buttonto disable IEEE 802.1Xauthentication.Memo• When changingIEEE802.1X authenticationfrom [ENABLE] to[DISABLE], press [Next],and on the “Confirm thefollowing settings” screenthat appears, press [APPLYNOW] to complete thesetting.CHECKSETTINGSPress this button to confirm theoptions currently selected.Note• [CHECK SETTINGS] isavailable when you selected[ENABLE] for 802.1X.FACTORYDEFAULTPress this button to reset theIEEE802.1X settings back to thefactory defaults.
