EDITING FUNCTIONS- 84 -21345675 Read the following 4 values to specify thearea using the left and top scales on thedocument glass.X1: From the top left to the left edge of the selectedareaX2: From the top left to the right edge of the selectedareaY1: From the top left to the upper edge of the selectedareaY2: From the top left to the lower edge of the selectedareaNote that the marks of the original scales have a 2 mm(0.08") pitch.6 Key in the read values.1) Press [X1], [X2], [Y1] and [Y2], and then key in theread values correspondingly.2) You can specify up to 4 areas on 1 page. Whenyou want to specify more than one area, press[AREA 1] to [AREA 4] to switch the area, and thenkey in the values correspondingly.3) Press [OK] after you have specified all the areas.7 Place the original again on the documentglass with its face down.Place it with its bottom right to you. Align its top sideagainst the left side of the document glass.8 Select other copy modes as required, andthen press the [START] button on thecontrol panel.Mirror image / Negative/positive reversalYou can reverse an image like a mirror (mirror image), or youcan reverse light-and-dark of an image (negative/positivereversal).1 Place paper in the tray(s).When using bypass copying, be sure to set the papersize.2 Place the original(s).3 Press [EDITING] on the EDIT menu.Mirror imageNegative/Positive reversal
