OfficeServ 7000 Series Call Server Programming Manual© SAMSUNG Electronics Co., Ltd. 2-261[724] DIAL NUMBERING PLANThis MMC allows the technician to change directory numbers for stations, trunks, stationgroups, trunk groups and feature access codes. The system can be pre-programmed withdefault 3- or 4-digit numbering for stations, station groups and trunk numbers dependingon the position of the DIP switches on the MCP card. There is an error message provided toprevent the accidental duplication of a directory number or feature access code.NO Type of Dial No Description00 STN NUMB. This is where station directory numbers are changed orassigned01 TRK NUMB. This is where trunk directory numbers are changed orassigned.02 VMAA NUMB. This is where VM/AA directory numbers are changed orassigned.03 MISC NUMB. This is where directory numbers for relays, MOH portsand the alarm sensor are changed or assigned.04 MGI NUMB. This is where MGI port directory numbers are changed orassigned.05 S0 NUMBER This is where directory numbers for BRI station ports arechanged or assigned. (This option may not be available incertain OfficeServ models.)06 MOBEX NUM This is where MOBEX directory numbers are changed orassigned.07 GROUP NUMBER This is where station or trunk group numbers are changedor assigned.08 FEATURE NUMBER This is where feature access codes are changed orassigned. Dialing codes are entered via the dial keypadby pressing a number the required number of times toselect the feature. For example, for OHVA, the number 6would be pressed three times.Please remember that this program is system-wide.09 NETWORK NUMBER This is where additional LCR access codes are entered iftwo or more OfficeServ 7000 Series systems arenetworked together.- LCR-xx: This codes will be translated by NTWK LCRDGT table in MMC824- RSXXXX: This codes will be translated by REMOTESTN table in MMC868
