OfficeServ 7000 Series Call Server Programming Manual© SAMSUNG Electronics Co., Ltd. 2-379[837] SIP OPTIONSThis MMC permits the adjustments of optional Session Initiation Protocol (SIP) trunkparameters. The MCP supports SIP and H.323 on a per-call-per-port basis. The settings aresystem wide.When changing IPWhen changing any IP address/value, listed below, three digits must be input foreach (octet) field. Example 192.168.1.10 input must be: 192 168 001 010SIP Stack ConfigurationNo Parameter Description Default00 RE-TRANS.T1The initial re-transmission time if there is no answer,based on the RFC2543 specification. The range is0~9900 ms.500 ms01 RE-TRANS.T2The maximum re-transmission time if there is no answer,based on the RFC2543 specification. The range is0~9900 ms.4000 ms02 RE-TRANS.T4The time the User Agent Server waits after receiving theACK message. Based on the RFC2543 specification.The range is 0~9900 ms.5000 ms03 GENERALRINGThe server retransmits the response for this length oftime until the requested retransmission is received.For example, the wait time after sending 200 OK forINFO. The range is 0~99900 ms.5000 ms04 INVITE RING After the client sends ACK for the INVITE Final Response, theclient cannot confirm if the server received the ACK message.The client waits for this length of time after sending ACKfor the Final Response. The range is 0~99900 ms.5000 ms05 PROVISIONAL After receiving the Provision Response, the User Agentwaits for this length of time until Timeout ends. The rangeis 0~999900 ms.180000 m06 INV NO RESP Before sending Cancel for the Invite Request, the UserAgent waits for this length of time. The range is 0~99900ms.5000 ms07 GEN NORESPBefore sending Cancel for General Request, the UserAgent waits for this length of time. The range is 0~99900ms.5000 ms08 REQ RETRY After sending General Request, the User Agent waits forthe Final Response for this length of time. The range is0~99900 ms.5000 ms
