CHAPTER 2. MMC Programming2-366 © SAMSUNG Electronics Co., Ltd.[833] VoIP IP TABLEThis MMC provides the IP addresses in tables pointed to by the VoIP code entry (MMC832). There are 251 tables with up to 4 entries each. The destination IP address is requiredto route dialed digits based on the access code and digits dialed. The IP entry field isdivided into 4 sections allowing modification of separate IP address fields.When changing IPWhen changing any IP address/value, listed below, three digits must be input foreach (octet) field. Example 192.168.1.10 input must be: 192 168 001 010No Option Description0 ENTRY 1 This indicates the first entry of each destination IP address table.1 ENTRY 2 This indicates the second entry of each destination IP address table.2 ENTRY 3 This indicates the third entry of each destination IP address table.3 ENTRY 4 This indicates the fourth entry of each destination IP address table.4 PROTOCOL Default value is SIP. Set PROTOCOL to H323 when the table is used forH323 signaling.6 ALIVE CHK Set ALIVE CHK to OPTION when the link test is required. When set,system sends OPTIONS message to the destination SIP Server.7 USER INFO Alphanumeric System username of To and From header in OPTIONSmessage. When empty, system does not send OPTIONS message tothe Destination SIP Server.8 RMT PORT Sets the port to use on the SIP Server.9 CHK TIMER When ALIVE CHK is set, CHK TIMER decides the message sendingtime interval.10 ALIVE STS ENTRY1 AVAIL: YES11 SIG TYPE This indicates the transport type in SIP message Signaling. SIPmessage can be transported either using UDP or TCP.(This option may not be available in certain OfficeServ models.)DEFAULT DATATB (000) ENTRY (00): MMC 830 SYSTEM IP ADDRPROTOCOL: SIPALIVE CHK: NONERMT PORT: 5060CHK TIMER: 1800ALIV STS: All ENTRY AVAIL are YESSIG TYPE: UDPALL OTHERS: EMPTY
