OfficeServ 7000 Series Call Server Programming Manual© SAMSUNG Electronics Co., Ltd. 2-361[831] MGI PARAMETERSThis MMC provides network configuration of the MGI/OAS card (s) in the system.No Parameter Description0 IP ADDRESS Specifies the IP address for the MGI card.1 GATEWAY Specifies the designated IP gateway address used for contactingIP devices beyond the local subnet.2 SUB MASK Specifies the IP subnet mask. This parameter is used by the system tocalculate the range of IP devices (subnet) that are within ‘direct reach’of the MGI. (without having to go through the designated network IPgateway)3 IP TYPE Specifies if the system will be routing data over a public or privatenetwork.4 LOCAL RTP Specifies local rtp port The default value is 30000 and the value rangeis between 10000 and 60000. If you use MPS function, the value mustbe not duplicated with MMC861 MPS local rtp port.This option is only shown in case of installed MGI 64/MGI16 card5 CARD RESET Reboots MGI card.6 PUB IP1 Pulbic IP Address is only used for VoIP signaling protocols in aNAT network . NAT system binds IP Address with Public IP andprocesses a voice stream. See System IP Type on MMC 830.7 PUB RTP1 Public RTP Port which NAT system binds a private RTP port with8 PUB IP2 Pulbic IP Address is only used for VoIP signaling protocols in aNAT network . NAT system binds IP Address with Public IP andprocesses a voice stream. See System IP Type on MMC 830.9 PUB RTP2 Public RTP Port which NAT system binds a private RTP port with10 PUB IP3 Pulbic IP Address is only used for VoIP signaling protocols in aNAT network . NAT system binds IP Address with Public IP andprocesses a voice stream. See System IP Type on MMC 830.11 PUB RTP3 Public RTP Port which NAT system binds a private RTP port with12 QOS MONIT. Specifies use of QOS. This option is only shown in case of installedMGI card. (not supportted MGI16/ 64)13 MAC ADDR Displays the MAC address of an MGI cardThis option is only shown in case of installed MGI64/MGI16 card.14 IP VERSION Specifies MGI IP version is Ipv4 / Ipv6. (This option may not beavailable in certain OfficeServ models.)If MP-MGI port (the embedded MGI) is selected, IP ADDRESS, GATEWAY, SUBMASK, CARD RESET parameters can not be set in this MMC because theseparameters and the system values are the same. The system values can bereferred in MMC830