168 EnglishINTRODUCTION SETTINGS NETWORKCONTROLNETWORKOPERATIONNETWORKSETTINGSOTHEROPERATION1 RECORDING IMAGESUse the following procedures to store monitored images andalarm images on the internal hard disk of the digital videorecorder.Before recording images, make the necessary menu settingsto match the installation environment. (JP.184)Use the following procedure to manually record live monitoredimages.1 Click the button on the operationpanel.Normal recording starts.2 Click the button on the operationpanel.Use the following procedure to automatically record monitoredimages in accordance with timer settings. Note that timerrecording cannot operate during normal recording.1 Set the conditions for timer recordingusing the “TIMER SET” screen.(JP.191)2 Click the button on the operationpanel.The unit enters standby mode for timer recording, andrecording then starts and stops automatically at the set times.The current status of timer recording is displayed on-screenwith the message “TIMER STANDBY” or “TIMERRECORDING”.z If “OLY AL-RC ON TMR” has been selected using the“ALARM REC MODE SET” menu item (JP.192), it is notnecessary to click the button on the operation panel toset up standby mode.3 To cancel timer recording, click thebutton on the operation panel while“TIMER STANDBY” is displayed.When an alarm is detected via the ALARM IN terminal or amotion sensor, the recording of alarm images startsautomatically.Use the alarm recording settings (JP.192) to activate alarmrecording, or set the alarm recording not to be performedduring timer recording.1 Set the conditions for “ALARMRECORDING” using the “ALARM RECMODE SET” screen. (JP.192)z Regardless of the unit’s current operation or status, alarmrecording starts automatically whenever an alarm isdetected.z When the duration set for alarm recording ends, alarmrecording stops automatically.z Settings can be made to generate a buzzer sound on thePC when an alarm occurs on the digital video recorder.(JP.194)z Click the button on the PLAYBACK area on theoperation panel to stop the alarm during alarm recording.Use the following procedure to set pre-alarm recording torecord video just before an alarm. Images can be viewed fromjust before an alarm when alarm recording is played back.1 Set the conditions for “PRE-ALARMRECORDING” using the “ALARM RECMODE SET” screen. (JP.194)z The newest images for the preset duration areautomatically recorded and updated by overwriting.z Pre-alarm recording is automatically terminated wheneveralarm recording starts, and it is automatically restarted asalarm recording ends.Normal recordingStopping normal recordingTimer recordingAlarm recordingPre-alarm recording
