INSTALLATION AND CONNECTIONS3English 17The SENSOR ALARM OUT terminals are used to relay alarmsignals whenever one of the digital video recorder’s motionsensors is triggered. Normally in an open condition, a terminaladopts a low condition when a sensor for the correspondingcamera number has been triggered.The connections for a remote control circuit are shown below.This digital video recorder can be remotely controlled when aremote-control circuit similar to that shown here is connectedto the remote-input control terminals.z Use a resistance of 1/10 ohms or more and with a Dranking (Precision within ±0.5%).z The remote control cable should be no more than 5 m long.* The DSR-5709P can operate up to nine cameras.1 After all other connections are made,make sure the voltage is 120 V-240 V ACand then insert the power plug into thewall outlet.There is no power switch. The display indicators flash, andafter a few moments, the monitor screen displays the cameravideo.z When turning the power on for the first time“PLEASE SET THE CLOCK” is displayed on the monitorscreen. Set the clock. (JP.20)z If the clock is already setThe operation display area is displayed.z If the ERROR indicator starts flashingThe digital video recorder has a self-diagnostic function tofind malfunctions. If a malfunction occurs while the poweris on, the ERROR indicator flashes in a cycle to indicatethe malfunction.If the ERROR indicator flashes, contact a Sanyo servicecenter.When flashing at 4Hz (Four times per second):The hard disk is checked automatically when the power isturned on. The POWER indicator flashing indicates that amalfunction has been found on the hard disk and the harddisk must be replaced or initialized. If you need to savevideo stored on the disk, contact a Sanyo service center.When flashing at 1Hz (Once per second):A fan malfunction has occurred.z The power cord’s ground terminal is not provided forenhanced safety; rather, it is used to reduce the level ofinterference when the digital video recorder is connected toanalog devices.If a large amount of noise is generated when the digitalvideo recorder is connected to analog devices, connectthis terminal to the building earth ground.Connecting SENSOR ALARM OUTterminalsConnecting control terminals1K Rated value of terminalsz Maximum current: 10 mAz Maximum power: 1/10 WREMOTEC R1 R2SW 1SW 2SW 3SW 4SW 5SW 6SW 7SW 8SW 9SW 10SW 11SW 12SW 13SW 14SW 15SW 16SW 17SW 18SW 19SW 20SW 21SW 22SW 23SW 24SW 25SW 26SW 27SW 28SW 29SW 30SW 31SW 32R1 R2: Camera 1:INDEX+: Camera 2:INDEX-: Camera 3:AUTO FOCUS:Camera 4 :Automatic selection display: Camera 5:Monitor2: Camera 6:Plus display: Camera 7:QUAD: Camera 8:MULTI: Camera 9:MENU RESET: Camera 10:Not used: Camera 11:PAN left: Camera 12:PAN right: Camera 13:TILT down: Camera 14:TILT up: Camera 15:ZOOM wide: Camera 16:ZOOM tele:REC/STOP:PLAY/STOP:STILL:SEARCH:SHIFT (Doubles with R1):PLAY:REC:MENU:MENU EXIT(EXIT): +: -: +: -:ZOOM:COPY:TIMER(When operatedindependently)(When combinedwith R2 FUNC key)Connecting the power cord120 V-240 V AC(50/60 Hz)02001-01-07 00:00:00 EN AOperationdisplay area
