180 EnglishINTRODUCTION SETTINGS NETWORKCONTROLNETWORKOPERATIONNETWORKSETTINGSOTHEROPERATION4 SAVING (COPYING) RECORDED VIDEOUse the following procedures to copy recorded images to thearchive area on the hard disk or to download images to a PCor the like.These functions can be used to save important images fromthe recording areas.z In certain cases where network-busy is detected as a resultof the operating environment, the network may be forciblydisconnected in order to protect DVR recording operations.Furthermore, the network is forcibly disconnected inresponse to commands to send a large amount of data in asingle operation (in particular, when 100 images or moreare to be saved), and in this case, the number of imagesshould be limited based on the hardware configuration inquestion.z When the archive area becomes full of images, downloadthese images to a USB memory or other storage mediaand click [AREA FULL RESET] from the recording areasettings on the “MAIN MENU.” (JP.187)z Can only save in full screen display. Cannot save for quad-screen or multi screen display.z Copied data is stored one image at a time. Moving imagescan be copied by setting the number of images requiredfrom the first copied image.(1) Recording date and time of the video that is being playedback.(2) PLAYBACK AREA: Type of video recording that is beingplayed back.z ALARM z PRE ALARM z NORMAL z ARCHIVE(3) MESSAGE: Displays a message when starting copy.(Example: PLEASE WAIT!)(4) UNIT: Select a method to specify copy range (number ofpictures, time and events).(5) AUDIO: Specify whether or not to copy audio.(6) PICTURES (1-40000): Specify the number of sheets,when “PICTURES” is specified in “UNIT”.(7) TIME: Specify hours, minutes and seconds, when “TIME”is specified in “UNIT”.(8) EVNETS: Enter the number of events, when “EVENT” isspecified in “UNIT”.(9) COPY CH: Select a channel to copy.(10) COPY TO: Fixed to “ARCHIVE AREA” (not selectable).(11) [START] button: Starts copying.(12) [CANCEL] button: Aborts copy.1 Play back video stored in recordingarea.2 Click the button on the controlpanel at the start point of copying video.Video stops to provide a still picture.3 Click the button on the controlpanel.The “COPY” screen is displayed.4 Specify a value for “UNIT”.[Settings] ( indicates default setting)z An event means a continuous record (or a recording unitset by “DURATION” for the alarm recording).z You can select “EVENTS” only when copying alarmrecording video.5 Specify for “AUDIO”.[Settings] ( indicates default setting)Copying to the archive area(1)(2)(10)(3)(4)(5)(9)(11) (12)(7) (8)(6)Setting DescriptionPICTURES Specifies the copy range with the numberof pictures.TIME Specifies the copy range with time (hours/minutes/seconds).EVENTS Specifies the copy range with the numberof events.Setting DescriptionON Also copies audio.OFF Does not copy audio.
