Sanyo PLC-WM5500/L - 5500 Lumens Manual

Also see for PLC-WM5500: Owner's manual Brochure Manual Owner's manual Command list

Contents

PLC-WM5500/WM5500L Expand Serial Command Functional Specifications16/88CR_FILH[CR] Get Filter used timeCR_FILTIMER[CR] Get time to display Filter cleaning / replacement warning onscreenCR_FILCOND[CR] Get status of filter clogCR_FILREPL[CR] Get status of Filter cleaning / replacement timeCR_FANSPEED [CR] Get selected Fan Control SpeedCR_SIMPLEMODE [CR] Get selected mode in Simple mode functionCR_RCODE [CR] Get selected Remote Control codeCR_RSENS [CR] Get selected location of infrared remote receiver of remotecontrolCR_RTYPE [CR] Get supported Remote Control type (IR/RF)CR_P-MANE [CR] Get Power management setting statusCR_P-MANETIME [CR] Get setting time for Power ManagementCR_STANDBYMODE [CR] Get selected mode of Standby functionCR_ON-STA [CR] Get setting status of Direct onCR_POINTER[CR] Get setting status of PointerCR_PTIMEMODE[CR] Get setting mode of P-timerCR_PTIMER[CR] Get status of P-timerCR_PTIME[CR] Get setting time for count down mode in P-timerCR_KEYDIS [CR] Get RC/KEY prohibited statusCR_SECURITY [CR] Get setting status of SecurityCR_PJLOCKNOW [CR] Get setting status of current PJ LockCR_PJLOCKMENU [CR] Get PJ Lock setting status on the menuCR_SHUTRCPROT[CR] Get remote controller disability status of the shutterCR_SHUTKEYPROT[CR] Get Key controller disability state of the shutterCR_SHUTH[CR] Get time setting to begin the shutter managementCR_CCAPTIONDISP[CR] Get setting status of channel of Closed captionCR_CCAPTIONCOLOR[CR]Get setting status of color of Closed captionCR_DELAYCTRL[CR] Get selected mode of Video delay controlCR_TESTPAT[CR] Get setting status of Test pattern6.9 Other Status Read Command TableStatus Read command ItemCR_STATUS [CR] Get operating status of ProjectorCR_SIGNAL [CR] Get status of signal existenceCR_VMUTE [CR] Get setting status of video mute (No show)CR_FREEZE [CR] Get setting status of FreezeCR_TEMPFAIL [CR] Get temperature when sensors approach abnormaltemperatureCR_TEMP [CR] Get current temperatureCR_SHUTCOND [CR] Get setting status of ShutterCR_SERIALNO [CR] Get value of SERIAL NO.