PLC-WM5500/WM5500L Expand Serial Command Functional Specifications71/889.8.6 CR_ KYSTNMODE CommandCommand “CR_KYSTNMODE” [CR]Details Get setting status of Keystone Store ModeAcceptable “000_%1” [CR]%1 “STR” ---------------------- Store mode is “Store”“RST” ---------------------- Store mode is “Reset”ResponseUnacceptable “?” [CR] -------------------- When unknown command is received9.8.7 CR_CORNERTESTPAT CommandCommand “CR_CORNERTESTPAT” [CR]Details Get setting status of test pattern for Corner correctionAcceptable “000_%1” [CR]%1“RED” ---------------------------- Test pattern is red“WHITE” ------------------------- Test pattern is white“BLUE” --------------------------- Test pattern is blue“OFF” ------------------------- Test pattern is not displayedResponseUnacceptable “Error Code” [CR]9.8.8 CR_CEIL CommandCommand “CR_CEIL” [CR]Details Get setting status of CeilingAcceptable “000_%1” [CR]%1 “ON” --------------------------- Ceiling projection is enabled“OFF” ------------------------- Ceiling projection is disabledResponseUnacceptable “Error Code” [CR]9.8.9 CR_REAR CommandCommand “CR_REAR” [CR]Details Get setting status of Rear functionAcceptable “000_%1” [CR]%1 “ON” --------------------------- Rear projection is enabled“OFF” ------------------------- Rear projection is disabledResponseUnacceptable “Error Code” [CR]9.8.10 CR_SCREENASPECT CommandCommand “CR_SCREENASPECT”[CR]Details Get status of Screen aspectAcceptable “000_%1”[CR]%1“43MODE” Select 4 3 mode“169MODE” Select 16 9 mode“1610MODE” Select 16 10 modeResponseUnacceptable “Error code”[CR]