Sanyo PLC-WM5500/L - 5500 Lumens Manual

Also see for PLC-WM5500: Owner's manual Brochure Manual Owner's manual Command list

Contents

PLC-WM5500/WM5500L Expand Serial Command Functional Specifications49/888.10.31 CF_POINTER CommandCommand “CF_POINTER_%1” [CR]%1“ARROW” ---------------------- Select Arrow Pointer“FINGER” ---------------------- Select Finger Pointer“LASER” ---------------------- Select Dot PointerDetailsSelect indication of Pointer. (Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting value remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.32 CF_PTIMEMODE CommandCommand “CF_PTIMEMODE_%1” [CR]%1 “COUNTUP” ---------------------- Set P-timer to Count up mode“COUNTDN” ---------------------- Set P-timer to Count down modeDetailsSelect count up/down mode of P-timer.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting value remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.33 CF_PTIMER CommandCommand “CF_PTIMER_%1” [CR]%1“START” -------------------------- Start P-timer“STOP” ---------------------------- Stop P-timer“RESTART” ---------------------- Resume P-timer“RST” ------------------------------ Reset P-timer“EXIT” ----------------------------- Exit P-timer functionDetails Select the status of P-timer.(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.34 CF_PTIME CommandCommand “CF_PTIME_%1” [CR]%1 “001” – “180” -------------------------- Directly specify setting timeDetailsSet the time for Count down mode of P-timer.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting value remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]