PLC-WM5500/WM5500L Expand Serial Command Functional Specifications31/888.6.7 CF_SYSTEM CommandCommand “CF_SYSTEM_%1” [CR]Input isPC Analog“VGA1” --------------------------- Select VGA1“VGA2” --------------------------- Select VGA2::“XGA1” --------------------------- Select XGA1::“WXGA3” --------------------- Select WXGA3“1080I” ------------------------ Select 1080i“1035I” ------------------------ Select 1035i“720P” ------------------------- Select 720p“575P” ------------------------- Select 575p“480P” ------------------------- Select 480p“575I” -------------------------- Select 575i“480I” -------------------------- Select 480i“1080PSF/24” ----------------- Select 1080psf/24“1080PSF/25” ----------------- Select 1080psf/25“1080PSF/30” ----------------- Select 1080psf/30“MODE1 - 10” ------- Select MODE1 – MODE10“EXT11 - 60” ------------- Select Ex Mode11-60* EX1-10 is not returned.Input isPC Digital/AVHDCP“D-XGA1” --------------------- Select D-XGA1::“D-WXGA3”------------------- Select D-WXGA3“D-1080I” --------------------- Select D-1080i“D-1035I” --------------------- Select D-1035i“D-720P” ----------------------- Select D-720p“D-575P” ----------------------- Select D-575p“D-480P” ----------------------- Select D-480p“D-1080PSF/24” --------------- Select D-1080psf/24“D-1080PSF/25” --------------- Select D-1080psf/25“D-1080PSF/30” ---------------- Select D-1080psf/30Input isY,Pb/Cb,Pr/Cr“AUTO” -------------------------- Select System “Auto”“1080P” --------------------------- Select 1080p“1080I” --------------------------- Select 1080i“1035I” -------------------------- Select 1035i“720P” --------------------------- Select 720p“575P” --------------------------- Select 575p“480P” --------------------------- Select 480p“575I” ---------------------------- Select 575i“480I” ---------------------------- Select 480i%1Input isVideo / S-Video“AUTO” -------------------------- Select System “Auto”“NTSC” -------------------------- Select NTSC“NTSC443” --------------------- Select NTSC4.43“PAL” ----------------------------- Select PAL“SECAM” ----------------------- Select SECAM“PAL-M” ------------------------- Select PAL-M“PAL-N” ------------------------- Select PAL-NDetailsSelect System of currently selected Input(Available only in the normal Power ON status)When selected input does not include specified %1, error code “101” [CR] isreturned and it is not executed.When Input No is 4, error code “101” [CR] is returned and it is not executed.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]