PLC-WM5500/WM5500L Expand Serial Command Functional Specifications37/888.7.13 CF_CORNERTESTPAT CommandCommand “CF_CORNERTESTPAT_%1”[CR]%1“RED” ------------Select Red“WHITE” -------- Select White“BLUE” ---------- Select Blue“OFF” ------------ Select OffDetailsDisplay test patterns for Corner correction.(Available in normal Power ON status only)The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.7.14 CF_CEIL CommandCommand “CF_CEIL_%1” [CR]%1 “ON” --------------------------- Set Ceiling to ON.“OFF” ------------------------- Set Ceiling to OFF.DetailsSet/Cancel Ceiling mode.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.7.15 CF_REAR CommandCommand “CF_REAR_%1” [CR]%1 “ON” --------------------------- Set Rear to ON.“OFF” ------------------------- Set Rear to OFF.DetailsSet/Cancel Rear mode (Available only in the normal Power ON status)When Rear is ON, projected image is left/right reversed.The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.7.16 CF_SCREENASPECT CommandCommand “CF_SCREENASPECT_%1”[CR]%1“43MODE” Select 4 3 mode“169MODE” Select 16 9 mode“1610MODE” Select 16 10 modeDetails Set Screen aspect mode.This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]
