Sanyo PLC-WM5500/L - 5500 Lumens Manual

Also see for PLC-WM5500: Owner's manual Brochure Manual Owner's manual Command list

Contents

PLC-WM5500/WM5500L Expand Serial Command Functional Specifications21/888.4.8 CF_COLTEMP CommandCommand “CF_COLTEMP_%1” [CR]%1“000” ------------------------------ Xlow“001”------------------------------- Low“002”------------------------------- Mid“003”------------------------------- HighDetailsSet Color TemperatureThe value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.9 CF_OFFSET- CommandCommand “CF_OFFSET-%1_%2” [CR]%1“R” --------- RED“G” --------- GREEN“B” --------- BLUE%2“000-063”------ Directly specify value of Color selected in %1 of Offset.“UP”------------ Increment setting value of Color specified in %1 of Offset by 1“DN”------------ Decrement setting value of Color specified in %1 of Offset by 1DetailsSet value of Color specified in %1 of Offset (Available only in the normal Power ONstatus)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code”[CR]8.4.10 CF_NZRED CommandCommand “CF_NZRED_%1” [CR]%1“OFF” ---------------- Cancel Noise Reduction“ON” ------------------- Set Noise Reduction“UP” ------------------ Toggle between ON and OFF. (On→OFF→On→...)“DN” ------------------ Toggle between ON and OFF. (On→OFF→On→...)*”UP” and “DN” are exactly same operation.DetailsSet Noise Reduction level (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memoryTherefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It returns to the original setting in Suspend mode as well.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]