PLC-WM5500/WM5500L Expand Serial Command Functional Specifications52/888.10.42 CF_DELAYCTRL CommandCommand “CF_DELAYCTRL_%1” [CR]%1“OFF”---------- Set Video delay control to OFF“LOW”---------- Set Video delay control to LOW“MID”---------- Set Video delay control to MID“HIGH”---------- Set Video delay control to HIGHDetailsSelect the mode of Video delay control(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.43 CF_TESTPAT CommandCommand “CF_TESTPAT_%1” [CR]%1“COLOR” ---------------------- Display Color bar“GRAD1” ---------------------- Display 16step(white→black)“GRAD2” ---------------------- Display 16step(white←black)“GRAD3” ---------------------- Display 16step(white↓black)“GRAD4” ---------------------- Display 16step(white↑black)“WHITE” ---------------------- Display all white“BLACK” ---------------------- Display all black“CROSS” --------------------- Display Cross“OFF” ---------------------Do not show test pattern display“UP” ---------------------- Switch forward“DN” ---------------------- Switch backwardDetails Execute test pattern display.(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.44 CF_FDEFAULT CommandCommand “CF_FDEFAULT_%1” [CR]%1 “RST”Details Reset to Factory Default setting(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]