Sanyo PLC-WM5500/L - 5500 Lumens Manual

Also see for PLC-WM5500: Owner's manual Brochure Manual Owner's manual Command list

Contents

PLC-WM5500/WM5500L Expand Serial Command Functional Specifications9/881 OverviewThis Functional Specification defines communication with PJ-Net organizer for PLC-WM5500 /WM5500L.Supporting Firmware Ver. 1.x of the projector.Commands in this document are to communicate with PJ-Net organizer, but most commands areused to control a projector remotely from a computer with RS-232C. Therefore commands in thisdocument are defined as Expand Serial Commands.2 Serial Interface Specification2.1 Transfer SpecificationItem SpecificationSynchronous System AsynchronousTransmission Speed 9600 / 19200Data Length 8 bitsParity N/AStop Bit 1Flow Control N/ANote1) Transmission Speed: initial setting value is 19200Note2) Transmission Speed can be changed in Service mode.2.2 ConnectionDedicated serial cables must be used for the connection between a computer and a projector.PC ProjectorCOM 1 CONTROL PORT(D-Sub 9Pin) (D-Sub 9Pin)Connect COM port of the computer to CONTROL PORT of the projector.COM Port (COM1 or COM2) of a computer is specified by control software of the computer.