PLC-WM5500/WM5500L Expand Serial Command Functional Specifications80/889.11.22 CR_SIMPLEMODE CommandCommand “CR_SIMPLEMODE” [CR]Details Get setting status of Simple mode.Acceptable “000_%1” [CR]%1 “ON” ------------------------ Simple mode is ON“OFF” ---------------------- Simple mode is OFFResponseUnacceptable “Error Code” [CR]9.11.23 CR_RCODE CommandCommand “CR_RCODE” [CR]Details Get selected Remote Control CodeAcceptable “000_%1” [CR]%1“001” --------------------------- Code 1 is selected“002” --------------------------- Code 2 is selected“003” --------------------------- Code 3 is selected“004” --------------------------- Code 4 is selected“005” --------------------------- Code 5 is selected“006” --------------------------- Code 6 is selected“007” --------------------------- Code 7 is selected“008” --------------------------- Code 8 is selectedResponseUnacceptable “Error Code” [CR]9.11.24 CR_RSENS CommandCommand “CR_RSENS” [CR]Details Get selected location of infrared remote receiver of remote controlAcceptable “000_%1” [CR]%1“ALL” -------- Select top, front and back receiver of projector“FRONTTOP” ----- Select front and top receiver of projector“BACKTOP” -------- Select back and top receiver of projector“FRONTBACK” ---- Select front and back receiver of projector“FRONT” ----- Select only front receiver of projector“TOP” --------- Select only top receiver of projector“BACK” ------- Select only back receiver of projectorResponseUnacceptable “Error Code” [CR]9.11.25 CR_RTYPE CommandCommand “CR_RTYPE” [CR]Details Get status of supported Remote Control (IR/RF).Acceptable “000_%1” [CR]%1“IR” -------- IR“RF” ------- RF (cannot be returned as this model supports onlyIR remote control)ResponseUnacceptable “Error Code” [CR]