Tascam TM-D4000 Owner's Manual

Also see for TM-D4000: Operation manual Technical documentation

Contents

9 - Machine Control—General parameters9–42 While holding down this key, also press andhold down the CLR key of the numeric key-pad [41].3 While holding down these two keys, press thekey of the number keypad corresponding tothe memory where the setting is to be stored(0 through 9).A pop-up window will appear, showing thatthe Machine Control Mapping setting hasbeen saved. NOTEThe machine control screen does not have tobe displayed for this operation.To recall a machine control mapping memory:1 Press and hold down the MACHINE SELECTkey [39].2 While holding down this key, press the key ofthe number keypad corresponding to thememory to be recalled (0 through 9).A pop-up window will appear showing thatthe Machine Control Mapping setting hasbeen recalled.9.1.5 Showing current Machine Controlmappings1 Press and hold down the SHIFT key [5].2 While holding this key down, press theMACHINE SELECT key [39].The display will show a list of all the cur-rently-stored Machine Control Mappings.3 To dismiss this popup list, press the ENTERkey.9.1.6 Automatically creating a list ofmachine control mapping memoriesWhen up to sixteen controllers have been added tothe machine control list from the list of supporteddevices, you can create a list of machine mappingmemories, each of which provides a transport con-troller for the different remote devices connected tothe TM-D4000, using the following procedure:1 Set up the CHASE, SCR and REC fieldsas needed.2 Press and hold down the SHIFT key [5].3 While holding down this key, press and holddown the CLR key [41].4 While holding down these two keys, press theMACHINE SELECT key [39]. The machinecontrol mapping list will be automaticallycreated from the list of machine entries andshown on screen.Memory 0 is the current setup, and the othermemories are then stored in order followingthis,9.2 General parametersWhen the SHIFT indicator is lit, press the MIDI/MCkey until the following screen appears:Use the cursor keys to navigate to the options in theMACHINE CONTROL section, and theENTER key to set parameters.9.2.1 Edit FramesWhen this is set on, location memories, etc. areedited to frame accuracy. When it is set to off, loca-tion is made to second accuracy.