10 - MIDI—MIDI controllers10–3WARNINGA change of snapshot may cause suddenchanges in level which, if you are not pre-pared for them, may result in damage to mon-itoring equipment. Be aware of these possiblelevel changes when making snapshotchanges.10.3.1Setting the Program Change tables1 Use the MIDI/MC SETUP screen. ThePROG. CHANGE TABLE section isat the bottom left:2 Move the cursor to select one of the fourbanks, and press ENTER.3 Use the JOG dial to scroll through the 128Program Change numbers (000 through127).4 When the Program Change number to beedited is highlighted, use the numeric keypadto enter the value of the snapshot to be asso-ciated with the highlighted Program Changenumber (snapshot numbers less than 10should be prefixed by a zero).5 Use the JOG dial and numeric keypad untilyou havce entered all the Program Changenumber/snapshot assignments you want touse into the current bank.6 Use the cursor keys to select another bank, ifnecessary.10.4MIDI controllersOne of the remote “devices” which may be set up inthe MIDI/MC MACHINE CTRL screen(see 9.1, “Selecting devices for control”) is theMIDI Controllers “device”.This allows the PODs of the TM-D4000 to be used asa bank of continuous controllers, sending ControlChange messages to an external MIDI device.The “ID” set in the MACHINE CTRL screencorresponds to the MIDI channel of the device to becontrolled.The names of the controllers correspond to the stan-dard MIDI controller names. Some of these controlsare off/off controls, although the POD continuouscontrols are used to make these settings.The Program Change POD (left POD, second row) isnot, of course, a Control Change message. Instead,turning the knob changes the value of the ProgramChange number. If the left switch of this POD is usedto turn the button ON, the Program Change messageis sent as the knob is turned. If the the button isturned OFF, the Program Change message corre-sponding to the current position of the knob will onlysent when the button is turned ON.The official MIDI specification defines the names ofthese controllers as follows:Controller name Number(decimal)Number(hex)MODULATION 1 01BREATH 2 02FOOT 4 04EXPRESSION 11 0BCH. VOL 7 07BALANCE 8 08PAN 10 0AEFF CTRL 1 12 0CEFF CTRL 2 13 0DSUSTAIN 64 40SOFT 67 43GPC1 16 10