Tutorial–Simple recording sessionTutorial T–2T2 Setup1. Power up your units in the following order: DA-38,your DAT machine, the TM-D4000, power amp/apeakers.2. Press the SHIFT key so that the indicator lights and thenpress the MIDI/MC key until the screen at right appears.3. Using the cursor keys move the cursor to the on-screenbutton AUTO-DETECT and press ENTER.4. The DA-38 should be detected and listed in theMachine Control List on this screen together with theappropriate unit ID. Chase mode should be OFF.5. Move the cursor up to the right of the line representingthe DA-38 in the Machine Control List and press ENTERtwice to engage Transport Control and Track Arming fromthe mixer. When you make this selection, the TM-D4000 also sends a command to the DA-38 to make theDIGITAL In setting.You may also want to set a check mark in the SCR box providing additional controls for the DA-38 fromthe mixer, but this step is not essential.6. Press the SHIFT key so that its indicator is unlit, thenpress DIGITAL I/O until the screen at right appears.7. Using the cursor keys move the cursor to the squarerepresenting SLOT1 and press ENTER.A box will appear asking you to confirm your selectionof the DA-38 connected to Slot #1 as the word clock master,press ENTER to confirm. On the far left angled surfaceof the mixer, under CLOCK the light indicating SLOTshould be lit.8. Press OPTION until the screen at left appears.9. Use the JOG DIAL (or the Cursor Keys) to movethe cursor to MDM ABS Absolute Time and press ENTER.This will display ABS time from the DA-38 on theTM-D4000's time counter.10. Insert a formatted tape into the DA-38 and test thetransport controls. The MDM LOCK indicator abovethe time counter should light when you press PLAY onthe TM-D4000's transport control, indicating theDTRS unit is communicating successfully with the mixer.