X ero x 4 5 95 Co pi e r/P ri n te r U s e r G u i de 10-171 0. M ai n te n an c e3. Discard all the punch scraps in an appropriate container.4. Insert the empty punch scrap container as far as possible.CAUTION: Pulling out the container and pushing it back intoplace resets the punch counter setting to 0. Make sure tocompletely empty the container so the counter number accuratelymatches the state of the container.5. Close the right cover of the light finisher.NOTE: A message will be displayed and the machine will notoperate if the right cover is even slightly open.Cleaning the MachineThe following section describes how to clean the machine.This section is divided into separate descriptions on how to cleanthe exterior, internal components, document cover/documentfeeder, and document glass.Cleaning the ExteriorThe following procedure describes how to clean the exterior.KEY POINT: Before you start to clean the machine, be sure toswitch off and unplug the machine. Cleaning the machine withoutswitching off the power may cause an electric shock.Do not use benzene, paint thinner, other volatile liquids, orspray insect repellent on the machine as doing so maydiscolor, deform, or crack covers.