X ero x 4 5 95 Co pi e r/P ri n te r U s e r G u i de 11-8711 . P ro b le m S o l vi n g8. Close the Finisher right cover.NOTE: A message will be displayed and the machine will notoperate if the right cover is even slightly open.If the staples cannot be removed after carrying out the aboveprocedures, contact the Customer Support Center.D2 FinisherThe following section describes the remedy for staple jams in thestaple cartridge for the D2 Finisher.1. Make sure that the machine has stopped and then open thefront cover on the light finisher.2. Hold the R1 at the position shown in the diagram and lift itslightly.3. Pull out the staple cartridge.NOTE: After removing the staple cartridge, check the inside of thefinisher for any remaining staples.4. Open the staple cartridge cover and remove the jammedstaple.5. If the jammed staple cannot be removed, push the staple inWARNING: Be careful whenremoving jammed staples toavoid hurting your fingers.