X ero x 4 5 95 Co pi e r/P ri n te r U s e r G u i de 11-111. Problem SolvingTroubleshootingThis section describes troubles that may occur with the machineand their solutions.Use the following information for troubleshooting procedures tosolve the problems.Power is not switched On. Cause Is the power switch on the machine turned off?No Yes Action Turn the power switch on.Refer to “Power on/off” on page 1-13.NoCause Is the power cord plugged into the power outlet?Action Turn the power switch off and then firmly plug in the powercord. Then turn the power switch on.Refer to “Power on/off” on page 1-13.NoCause Is the power cord disconnected from the machine or therear of the rack?Action Turn the power switch off and then firmly plug in the powercord. Then turn the power switch on.Refer to “Power on/off” on page 1-13.NoCause Is power of the correct voltage being supplied?Action Make sure that the power supply is 200 -240 V (volts),15 A (amperes).Make sure that power of capacity compatible with thespecified maximum power consumption of the machine(2.8 - 3.1 KVA) is being supplied.Display is dark. Cause Is the Power Saver button on?No Yes Action The machine is in the Power Saver mode. Press thePower Saver button to cancel the Power Saver mode.Refer to “Power Saver Mode” on page 1-15.NoCause Is the Brightness Dial set too low?Action Use the Brightness Dial to adjust display brightness.Refer to “Control Panel” on page 1-9.