System Guide 1- 13Gateway and Network ConfigurationNOTE: It is recommended to set this after the first connect attempthas been made since the Preferred Server Name should beautomatically available under normal conditions.NetWare gateway configurationIn Gateways using the NetWare tab, the administrator canconfigure the NetWare Network automatically or manually. If theautomatic mode is selected, a “wizard” steps the administratorthrough the configuration of the Novell Server and the NetWarePrinter queues for the Xerox FreeFlow Print Server.If the manual mode is selected, the interface enables manualentry and filtering for the Novell setups and printer queues.LPD gateway configurationIn Gateways using the LPD (Line Printer Daemon) tab, theadministrator can enable or disable the LPD protocol, set thedefault queue, and set the LPD port. The default port is 515, themost commonly used port.Network configuration settingsWithin the System Administration part of the user interface,Network configuration options are presented.IP configurationIn Network Configuration, using the IP Address tab, theadministrator can enable or disable IP. If IP is enabled, theadministrator can adjust or change the following settings:• IP Address• Host name• Subnet mask• Default gatewayThe administrator must also select the IP Configuration Method.The drop down menu presents two options: a “Static” IPconfiguration which allows the user to specify the IP values, or“DHCP” method which allows a DHCP server to provide IPinformation.NOTE: The user is prompted whenever a reboot is required.
