8 Faxing8-6 Xerox Phaser 3200MFPThe document types recommended for the resolution settings are describedin the table below:NOTE: For memory transmission, Super Fine mode is not available. Theresolution setting is automatically changed to Fine.When your machine is set to Super Fine resolution and the receiving faxmachine does not support Super Fine resolution, the machine transmits usingthe highest resolution mode supported by the other fax machine.Sending a Fax Automatically1. Load the document(s) face up into the ADF, or place a single documentface down on the document glass.For details about loading a document, see Loading a Document onpage 8-4.2. Press the Fax button.3. Adjust the document resolution to suit your fax needs (see Adjusting theDocument Resolution on page 8-5).If you need to change the brightness, see Lighten/Darken on page 8-2.4. Enter the remote fax phone number using the number keypad.You can also press and hold the digit button of the speed dial number ifyou have assigned one. To store the speed dial number, see Storing aNumber for Speed Dialing on page 8-13.5. Press Start.6. When a document is placed on the document glass, the display shows“Another Page?” on the top line after the document is scanned into thememory. If you have the next page, remove the scanned page and placeMode Recommended for:Standard Documents with normal sized characters.Fine Documents containing small characters or thin lines ordocuments printed using a dot-matrix printer.Super Fine Documents containing extremely fine detail. Super Fine modeis enabled only if the machine with which you arecommunicating also supports the Super Fine resolution. Seethe notes below.Photo Documents containing shades of gray or photographs.Color Documents with colors. Sending a color fax is only possible ifthe receiving machine supports color fax reception and yousend the fax manually. In this mode, memory transmission isnot available.
