3 Network SetupXerox Phaser 3200MFP 3-3Configuring TCP/IPYour machine can be set up with a variety of TCP/IP network information, suchas an IP address, a subnet mask, and a gateway. There are several ways inwhich your machine can be assigned a TCP/IP address, depending on yournetwork.• Dynamic addressing via BOOTP/DHCP (default): A TCP/IP address isassigned automatically by the server.• Static addressing: A TCP/IP address is assigned manually by the systemadministrator.NOTE: Before configuring TCP/IP, you need to set the network protocol toTCP/IP.Dynamic addressing (BOOTP/DHCP)To have a TCP/IP address assigned automatically by the server, take thefollowing steps:1. Press Menu until Network Setup appears on the top line of the display.2. Press the scroll button ( or ) until "Config Network" appears and pressEnter.3. Press Enter when "TCP/IP" appears.4. Press the scroll button ( or ) until "DHCP" or "BOOTP" appears andpress Enter.5. Press Stop/Clear to return to Standby mode.Static addressingTo enter a TCP/IP address from your machine’s control panel, take thefollowing steps:1. Press Menu until "Network Setup" appears on the top line of the display.2. Press the scroll button ( or ) until "Config Network" appears and pressEnter.3. Press Enter when "TCP/IP" appears.4. Press Enter when "Manual" appears.5. Press Enter when "IP Address" appears.6. Enter a byte between 0 and 255 using the number keypad and press thescroll button ( or ) to move between bytes.7. Repeat this to complete the address from the 1st byte to the 4th byte.8. When you have finished, press Enter.
