Copy WorkCentre ® XXXXUser Guide 103• Off applies no binding edge erase to the output.• Both Pages scans both pages, the left page of the book will be scanned first. Use the arrowbuttons to specify an amount from 0 to 50mm (0 to 2”) to be deleted from the center ofthe book image.• Left Page Only scans the left page only. Use the arrow buttons to specify an amount from0 to 25mm (0 to 1”) to be deleted from the right side of the page image.• Right Page Only scans the right page only. Use the arrow buttons to specify an amountfrom 0 to 25mm (0 to 1”) to be deleted from the left side of the page image.9. Select the OK button.10. Enter the number of prints required using the numeric keypad on the control panel.11. Press the Start button on the control panel to scan the original.12. Remove the original from the document feeder or document glass when scanning hascompleted. The job enters the job list ready for processing.13. Press the Job Status button on the device control panel to view the job list and check the statusof the job.14. If your job remains held in the Active Jobs list, the device needs you to supply additionalresources, such as paper or staples before it can complete the job. To find out what resourcesare needed, select the job and then select the Details button. Once the resources are availablethe job will print.More InformationBuilding a Copy Job with Multiple Page or Segment SettingsUsing a User ID to Log In at the DeviceViewing the Progress and Details of a Job using the Job Status MenuSpecifying the Size of the Original to be CopiedUsing the Image Shift Feature to Reposition the Copy ImageWhen you press the Start button to make a copy, the device scans your originals and temporarilystores the images. It then prints the images based on the selections made.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Copy features.Use the Image Shift option to move the position of the image on the output page. This is usefulwhen the output needs to be bound as it allows you to move the image to the left or right to leaveenough room for the binding.1. Load your documents face up in the document feeder input tray. Adjust the guide to just touchthe documents.OrLift up the document feeder. Place the document face down onto the document glass andregister it to the arrow at the top left corner. Close the document feeder.2. Press the Clear All button on the control panel to cancel any previous programming selections.3. Press the Services Home button.4. Select the Copy button on the touch screen.5. Select the Layout Adjustment tab.6. Select the Image Shift button.
