Scan WorkCentre ® XXXXUser Guide 289Lift up the document feeder. Place the first segment face down onto the document glass andregister it to the arrow at the top left corner. Close the document feeder.6. Select the Build Job button.7. Select the On button to turn the Build Job feature on and enable the Build Job options.• If required, select the Off button to cancel any programming you have entered.8. If required, select the options for the segment.9. Press the Start button on the control panel to scan the original.10. Remove the first segment originals after they have been scanned. The Build Job screen displaysthe first segment in the list.11. Load the second segment originals.12. Select the features required for the second segment.13. Press the Start button on the control panel to scan the original.14. Repeat these steps until all segments of your job have been programmed and scanned.15. After the last segment has been scanned, select the Submit Job button.16. Press the Job Status button on the device control panel to view the job list and check the statusof the job.17. Remove the original from the document feeder or document glass when scanning hascompleted.18. Press the Job Status button on the device control panel to view the job list and check the statusof the job.More InformationUsing a User ID to Log In at the DeviceSystem Administrator Guide www.xerox.com/support.Using Internet Services to find System Administrator Contact DetailsSetting the Output Color for a Single-Touch ScanThe Single-Touch Scan feature is a fast and convenient way to scan a document and send it to apredefined scan destination on your computer or network location.Your System Administrator will create a button on the device touch screen for each Single-TouchScan destination (up to 10 buttons) and can customize the color scheme, logo and instructionaltext that displays when you select the Single-Touch Scan button. Your System Administrator canalso change the name of the Single-Touch Scan button.The Single-Touch Scan service can be configured with scan settings already specified so that youcan scan your document quickly. Your System Administrator can also customize the service so thatyou can select the Build Job, Output Color, Original Type, 2-Sided Scanning and File Name settingseach time you scan your document.Note: This option must be made available by your System Administrator.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Single-Touch Scan feature.
