Copy WorkCentre ® XXXXUser Guide 874. Select the Copy button on the touch screen.5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.6. If required, select the More... button at the bottom of the Copy Output section to access all thefinishing options. The number of options displayed will depend upon the finishing device andkits installed (there may not be enough to require a More... button).7. Select the Copy Output option required.• Uncollated sorts your copies into stacks 1,1,1 2,2,2 3,3,3.• Collated sorts your copies into sets 1,2,3 1,2,3 1,2,3.• Stapled• Hole Punched / Stapled• Booklet8. Select the OK button.9. Enter the number of prints required using the numeric keypad on the control panel.10. Press the Start button on the control panel to scan the original.11. Remove the original from the document feeder or document glass when scanning hascompleted. The job enters the job list ready for processing.12. Press the Job Status button on the device control panel to view the job list and check the statusof the job.13. If your job remains held in the Active Jobs list, the device needs you to supply additionalresources, such as paper or staples before it can complete the job. To find out what resourcesare needed, select the job and then select the Details button. Once the resources are availablethe job will print.More InformationCollating CopiesStapling CopiesHole Punching CopiesPreparing Copies to be made into a BookletUsing a User ID to Log In at the DeviceViewing the Progress and Details of a Job using the Job Status MenuDescribing the Finishing DevicesIdentifying the WorkCentre 5945 Standard and Optional ServicesIdentifying the WorkCentre 5955 Standard and Optional ServicesCollating CopiesWhen you press the Start button to make a copy, the device scans your originals and temporarilystores the images. It then prints the images based on the selections made.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Copy features.Depending on the optional finishing device and kits installed you will have the choice of differentoutput options such as stapling, folding and collating.
