Copy WorkCentre ® XXXX80 User GuideCopy OptionsReduce or EnlargeReducing or Enlarging CopiesWhen you press the Start button to make a copy, the device scans your originals and temporarilystores the images. It then prints the images based on the selections made.If Authentication or Accounting has been enabled on your device you may have to enter logindetails to access the Copy features.A variety of options are available on your device to enable you to reduce or enlarge the output fromyour original. You can input a specific reduction or enlargement ratio, or choose from a selection ofpre-defined options.1. Load your documents face up in the document feeder input tray. Adjust the guide to just touchthe documents.OrLift up the document feeder. Place the document face down onto the document glass andregister it to the arrow at the top left corner. Close the document feeder.2. Press the Clear All button on the control panel to cancel any previous programming selections.3. Press the Services Home button.4. Select the Copy button on the touch screen.5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.P
