Yaesu FT DX 3000 Operating Manual

Also see for FT DX 3000: Operating manual Operating manual Operating manual Operating manual Operating manual

Contents

Page 114 FT DX 3000 O peraTing M anualDVS Group015 RX OUT LEVELFunction: Sets the audio output level from the optionalDVS-6 Voice Memory Unit.Available Values: 0 ~ 100Default: 50Advice:If the optional DVS-6 Voice Memory Unit is notconnected, this adjustment has no effect.016 TX OUT LVLFunction: Sets the microphone input level to the optionalDVS-6 Voice Memory UnitAvailable Values: 0 ~ 100Default: 50Advice:If the optional DVS-6 Voice Memory Unit is notconnected, this adjustment has no effect.KEYER Group017 F KEYER TYPEFunction: Selects the desired keyer operation mode forthe device connected to the front panel KEY jack.Available Values: OFF/BUG/ELEKEY/ACSDefault Setting: ELEKEYOFF: Disables the front panel keyer (“straightkey” mode for use with external keyer orcomputer-driven keying interface).BUG: Mechanical “bug” keyer emulation. Onepaddle produces “dits” automatically, whilethe other paddle manually produces “dahs”.ELEKEY: Iambic keyer with ACS (Automatic CharacterSpacing) disabled.ACS: Iambic keyer with ACS (Automatic CharacterSpacing) enabled.018 F CW KEYERFunction: Selects the keyer paddle wiring configurationfor the KEY jack on the front panel.Available Values: NOR/REVDefault Setting: NORNOR: Tip = Dot, Ring = Dash, Shaft = GroundREV: Tip = Dash, Ring = Dot, Shaft = Ground019 A1A R-TYPEFunction: Selects the desired keyer operation mode forthe device connected to the rear panel KEY jack.Available Values: OFF/BUG/ELEKEY/ACSDefault Setting: ELEKEYOFF: Disables the rear panel keyer (“straightkey” mode for use with external keyer orcomputer-driven keying interface).BUG: Mechanical “bug” keyer emulation. Onepaddle produces “dits” automatically, whilethe other paddle manually produces “dahs”.ELEKEY: Iambic keyer with ACS (Automatic CharacterSpacing) disabled.ACS: Iambic keyer with ACS (Automatic CharacterSpacing) enabled.020 R CW KEYERFunction: Selects the keyer paddle wiring configurationfor the KEY jack on the rear panel.Available Values: NOR/REVDefault Setting: NORNOR: Tip = Dot, Ring = Dash, Shaft = GroundREV: Tip = Dash, Ring = Dot, Shaft = Ground021 ELEKEY TYPEFunction: Selects the operation mode of the internalkeyer.Available Values: ELEKEY-A/ELEKEY-BDefault Setting: ELEKEY-B022 CW WEIGHTFunction: Sets the Dot:Dash ratio for the built-inelectronic keyer.Available Values: (1:) 2.5 ~ 4.5Default Setting: 3.0023 BEACON TIMEFunction: Sets the interval time between repeats of thebeacon message.Available Values: OFF/1 ~ 240 sec (1 sec/step)/270 ~690 sec (30 sec/step)Default Setting: OFFM enu MODe