Yaesu FT DX 3000 Operating Manual

Also see for FT DX 3000: Operating manual Operating manual Operating manual Operating manual Operating manual

Contents

Page 35FT DX 3000 O peraTing M anualopeRAtioN oN 60-M eteR (5 MH z) bANd (u.S. ANd u.K. veRSioN oNly)The recently-released 60-meter band is covered, in the FTDX 3000, by fixed memory channels. These channels are set toUSB or CW, and they appear between the “last” PMS channel (“P9U”) and the first “regular” memory channel (Channel1):1. Press the [V/M] button once to enter the “Memory”mode; the “MCH” icon will appear in the displayand a memory channel number will appear on thedisplay.A dvice :If you can not enter the “Memory” mode, the trans-ceiver may be in [(VFO-B)RX], so check to see ifthe green [(VFO-B)RX] Indicator/Switch is illu-minated). If so, press the [(VFO-A)RX] Indicator/Switch to return operation to VFO-A. Now, press the[V/M] button to enter the “Memory” mode.2. Press the [MCH] button located on the bottom rightof the [CLAR/VFO-B] knob. The LED imbedded inthe button will glow orange to signify that rotation ofthe [CLAR/VFO-B] knob will allow selection of thememory channel.3. Memory channels (“5M-01” through “5M-10”) arepre-programmed, at the factory, with the permittedfrequencies in the 5 MHz band, and the USB or CWmode is automatically selected on these channels.4. To exit from 60-meter operation and return to theVFO mode, just press the [V/M] button.N ote:The frequencies and operating mode for 5 MHz bandoperation are fixed, and may not be changed.Basic O peraTiOn:receiving On aMaTeur BanDs[CLAR/VFO-B] Knob[VFO-B(RX)] Button[MCH] Button[V/M] Button[VFO-A(RX)] ButtonMain Tuning Dial KnobcHANNelN uMbeR5M-015M-025M-035M-045M-055M-065M-075M-085M-095M-10u.S. veRSioN5.332000 MHz5.348000 MHz5.358500 MHz5.373000 MHz5.405000 MHz5.332000 MHz5.348000 MHz5.358500 MHz5.373000 MHz5.405000 MHzu.K. veRSioN5.260000 MHz5.280000 MHz5.290000 MHz5.368000 MHz5.373000 MHz5.400000 MHz5.405000 MHz---FReQueNcy