Yaesu FT DX 3000 Operating Manual

Also see for FT DX 3000: Operating manual Operating manual Operating manual Operating manual Operating manual

Contents

Page 87FT DX 3000 O peraTing M anualcOnTesT memOry keyer (U sing The Fh-2 remOTe cOnTrOl keypAd)cW cOnvenience FeaTureSTeXT messAge prOgrAmming1. Press the [MODE] button to set the operating modeto CW.2. Be sure that Break-in is “Off” by pressing the [BK-IN] button, if necessary.3. Press the FH-2 [MEM] key. A blinking “REC” iconwill appear in the display.4. Press an FH-2 [1] ~ [5] key to select the desired CWMemory Register into which you wish to programthe text, the blinking “REC” icon will disappear.5. Use the FH-2 [t] and [u] keys to set the cursorposition and use the FH-2’s [p] and [q] keys tochoose the letter/number to be programmed in eachslot of the memory. In the case of the second ex-ample above, the “#” character designates the slotwhere the Contest Number will appear.A dvice :You may also use the Main Tuning Dial knob andthe [CLAR/VFO-B] knobs to program the messagecharacters.6. When the message is complete, add the “}” characterat the end to signify the termination of the message.7. Press and hold in the FH-2 [MEM] key for one sec-ond to exit, once all characters (including “}”) havebeen programmed.checking The cw memOry cOnTenTs1. Be sure that Break-in is still turned “Off” by the[BK-IN] key.2. Press the [MONI] button to enable the CW monitor.3. Press an FH-2 [1] ~ [5] key, whichever memory youjust recorded in. You will hear the results in the sid-etone, but no RF energy will be transmitted.On -The -A ir cw messAge plAybAck1. Press the [BK-IN] button to enable transmission. Ei-ther Full-break-in or Semi-break-in will be engaged,depending on the setting of Menu item “061 CWBK-IN”.2. Press an FH-2 [1] ~ [5] key, depending on whichCW Memory Register message you wish to transmit.The programmed message will be transmitted on theair.